Awning Installed On A Slide Out

In these cases it is best to contact your local dometic retailer for a consultation.

Awning installed on a slide out.

Unroll some of the fabric from the roller tube. Upon parking the awning can be pulled and slid out to create shade or canopy. Before installing the awning clean the end of the rail and spray the insides with silicone lubricant. Slide the polyrod and fabric into the awning rail.

The integrated wind deflector prevents billowing and provides fabric protection for when you travel. Slide out retractable awnings like a pull down window shade the slide out awning is normally placed on most sides of an rv. Keep your rv slide outs protected with our new line of rv slide out covers. Detail a slide the end cap extension onto the mounting bracket.

Rv slide out awning installation is a relatively simple process that requires two sets of hands and about an hour of your time and this small addition will work wonders in keeping debris such as sticks and leaves off of the top of your awning which has been known to damage the top seal of your sidewall cut out and cause potentially major leakage inside the cabin. The 3 clearance you re needing is side to side the arms of your current awning should be at least 3 outside of the slide out on each end. Roll up the slack material onto the roller tube. Repeat for the other side.

Center the fabric over the room. Step 2 insert the end caps on either side of the mounting bracket. Now you don t have to worry about damages to your slide outs and you can now protect the life of your rv better against the elements with our special slide covers. Dometic slide topper awnings come with a full case or a wind deflector and protects your slide seals from leaves and rainfall.

Make sure to center the fabric. Do not attach at this time. Step 3 unroll some of the awning fabric from the roller tube and slide it into the awning rail.